Support
model
- 392 -
GS ( A pL pH n m
[Function] Execution of test printing
[Code] <1D>H<28>H<41>H<pL><pH><n><m>
[Range] (pL+(pH×256))=2 (pL=2, pH=0)
0≤n≤2, 48≤n≤50
1≤m≤4, 49≤m≤52
[Outline] [The specification which is common to the model]
• Specified test printing will be executed.
• pL, pH will specify the number of subsequent parameters by (pL+(pHx256))bytes.
• “n” will specify the paper for test printing in the following table.
Basic paper (Paper rolls)
1, 49
2, 50
Paper rolls
• “m” will specify the category of test printing in the following table.
Category of Test Printing
2, 50
Printer’s status printing
3, 51 Rolling pattern printing
[The specification which depend on the model]
CT-P29x series
Category of Test Printing
2, 50
Printer’s status printing
3, 51 Rolling pattern printing
4, 52
Memory Switch sitting printing
CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II)/CT-S251/CT-D151/CT-E651
• Only Bluetooth I/F
Category of Test Printing
、
2、50
Printer’s status printing
、
10、58
Bluetooth Communication
Information printing