T-Series Traffic Director Installation, Configuration and Administration Guide 5-3
Using the T1000 Graphical User Interface (GUI)
• Red Hat Linux 5.0 and 6.0 operating systems: Firefox 3.0 (or higher).
Using the Configuration Utility
Once you log on to the configuration utility, you can configure the T1000 through a
graphical interface that includes context-sensitive help. If your computer does not have a
supported Java plug-in installed, the first time you log on to the T1000, the configuration
utility will prompt you to download and install the plug-in.
Note: Prior to installing the Java 2 Runtime Environment, ensure that you have
installed the full set of required operating system patches needed for the current
Java release.
To log on to the configuration utility:
Step 1 Open your web browser and enter the T1000 IP as an HTTP address. If you have not yet set
up the initial configuration, enter the default NSIP (http://192.168.100.1). The Logon page
appears.
Note: If you have two T1000 appliances in a high availability setup, make sure that
you do not access the GUI by entering the IP address of the secondary T1000. If
you do so and use the GUI to configure the secondary T1000, your
configuration changes will not be applied to the primary T1000.
Step 2 In the User Name text box, type nsroot.
Step 3 In the Password text box, type the administrative password you assigned to the nsroot
account during initial configuration.
Step 4 In the Start in list, click Configuration, and then click Login. The Configuration Utility
page appears.
Note: If your workstation does not already have a supported version of the Java
runtime plug-in installed, the T1000 prompts you to download the Java Plug-in.
After the download is complete, the configuration utility page appears.
If you need to access the online help, select Help from the Help menu at the top right corner.
Using the Statistical Utility
Dashboard, the statistical utility, is a browser-based application that displays charts and
tables on which you can monitor the performance of a T1000.
To log on to Dashboard:
Step 1 Open your web browser and enter the T1000 IP as an HTTP address (http://IP>). The Logon
page appears.
Step 2 In the User Name text box, type nsroot.
To Next Page
Loading...
Need help?
General
