T-Series Traffic Director Installation, Configuration and Administration Guide 3-9
Configuring T1000 Basic Functions
> add route Network 0.0.0.0 0.0.0.0 10.8.130.254
Done
> save ns config
Done
Setting Host Name
The following example shows how to configure the hostname of the T1000:
> set ns hostName T1000-1
Done
> save ns config
Done
> reboot
Requesting a License
Request a license from Bytemobile Support. You will be required to provide the following
information for the license:
• Network Architecture.
• License Model (based on number of subscribers, amount of data, enforcement type).
• Optional features purchased by the customer.
• Host ID and hardware type.
To retrieve the T1000 Host ID:
> shell
root@T1000-1#lmutil lmhostid -ether
The FLEXnet host ID of this machine is "123456789ABCDEF"
Verifying Operating System
The T1000 will be shipped with an appropriate operating system image. You should verify
the version prior to continuing.
To display OS version from the CLI:
> show ns version
NetScaler NSX.X: Build 60.3007.e.nc, Date: Feb 28 2013, 09:05:58
Ensure both T1000s have the same image. Also ensure that the installed version matches or
is greater than the Build 60.3007.e.nc version mentioned above.
If the OS version is lower than the recommended value, contact Bytemobile Support. To
upgrade the OS, see “Upgrading the T1000 Operating System” on page 5-4.
Configuring NTP
The following example shows how to configure a primary and a secondary NTP server and
set the poll period from 64 to 1024 seconds. Use values appropriate to your network.
Note: NTP transactions occur on the management interface. Ensure the management
network is configured and operational. See “Accessing and Configuring the
Management Plane” on page 2-29.
To Next Page
Loading...
Need help?
General
