B-2 T-Series Traffic Director Installation, Configuration and Administration Guide
Appendix B Replacement Parts
Replacing an AC Power Supply
Use the following procedure to replace a failed AC power supply in the T1000.
Step 1 Read the safety information in the “Safety Information” section on page iii.
Step 2 Locate a replacement AC power supply and remove from the packaging. Place the power
supply within reach during this replacement procedure. Retain the packaging materials for
storage/return of the failed unit.
Caution Ensure you have the correct power supply type. You cannot combine power
supplies of different types/wattages in the same unit.
Caution Statement 8:
Never remove the cover on a power supply or any part that has the
following label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts
inside these components. If you suspect a problem with one of these parts,
contact a service technician.
Caution:
Statement 5:
The power control button on the device and the power switch on the power supply do
not turn off the electrical current supplied to the device. The device also might have
more than one power cord. To remove all electrical current from the device, ensure
that all power cords are disconnected from the power source.
1
2
To Next Page
Loading...
Need help?
General
