EasyManuals Logo

Citrix ByteMobile T1010 User Manual

Default Icon
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
T-Series Traffic Director Installation, Configuration and Administration Guide 5-7
Installing/Upgrading T1000 License
12. If the appliance is not a primary appliance, then run the following command to
perform a force failover to ensure that the appliance is a primary appliance:
> force failover
13. Verify that the appliance is a primary appliance.
Enabling Synchronization on the Secondary Appliance
To enable synchronization on the secondary appliance, complete the following procedure:
1. Run the following command to verify that the appliance is a secondary appliance:
> show node
2. Run the following command to enable synchronization on the appliance:
> set node -hasync enable
3. Run the following command to verify that the configuration of the secondary
appliance is synchronized with that of the primary appliance:
> show ns runningconfig
Installing/Upgrading T1000 License
Before you deploy a T1000 on the network, you must get the appliance licensed
appropriately. The T1000 includes a pre-installed license. License upgrades must be
obtained from Bytemobile.
Licenses must be copied to the /nsconfig/license directory on the appliance using secure
copy or FTP. Create the /nsconfig/license directory if it does not exist. Licenses are read at
startup, therefore allowing features to be enabled by the appliance. For complete license
installation instructions, see the Citrix NetScaler Migration Guide.
To install the licenses using the configuration utility, complete any of the following
procedure:
Software Release Earlier Than 10
Software Release 10 or Later
Software Release Earlier Than 10
To install the licenses using the configuration utility with software release earlier than 10,
complete the following procedure:
1. In a Web browser, type the IP address of the appliance, such as http://192.168.100.1.
2. In User Name and Password, type the administrator credentials.
3. In the navigation pane, expand the System node.
4. Select the Licenses node.
5. Click Manage Licenses.
6. Click Add.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Citrix ByteMobile T1010 and is the answer not in the manual?

Citrix ByteMobile T1010 Specifications

General IconGeneral
BrandCitrix
ModelByteMobile T1010
CategoryNetwork Hardware
LanguageEnglish

Related product manuals