Contents
xii T-Series Traffic Director Installation, Configuration and Administration Guide
Rack Mounting the T1000 2-8
Making Data Plane Connections 2-11
Making Management Connections 2-18
Connecting and Disconnecting AC Power 2-19
Connecting and Disconnecting DC Power 2-22
Accessing and Configuring the Management Plane 2-29
Accessing and Configuring the LOM Port 2-31
Chapter 3 Basic T1000/Unison Load-Balancing Configuration
Physical Integration of T1000 with Unison 3-2
Managing Configurations 3-3
Assigning VLANs, IP Addresses, and Ports 3-4
Configuring T1000 Basic Functions 3-8
Configuring T1000 Data Plane for Layer-2 and Layer-3 3-11
Configuring T1000 Load Balancing 3-17
Configuring Health Checks and Redundancy 3-22
Configuring Source NAT (SNAT) 3-26
Configuring Security 3-27
Testing with Network Diagnostic and Shell Tools 3-29
Chapter 4 Dynamic Routing Protocol Configuration for T1000/Unison
Overview 4-1
OSPF Protocol and Setup 4-1
OSPF Configuration 4-2
Chapter 5 Administration
Using the T1000 Command Line Interface (CLI) 5-1
Using the T1000 Graphical User Interface (GUI) 5-2
Lights-Out Management 5-4
Upgrading the T1000 Operating System 5-4
Installing/Upgrading T1000 License 5-7
Authentication and Authorization 5-9
Configuring SNMP 5-15
Collecting Real-Time Statistics from the CLI 5-23
Advanced Administration 5-23
Appendix A T1000 Specifications
Environmental Specifications A-1
Power Characteristics A-2
Physical Characteristics A-3
Regulatory Compliance A-4
To Next Page
Loading...
Need help?
General
