Climax Mobile Pro - Local RF Device Management

37
5. Local RF Device Management
Mobile Lite can learn up to 5 RF devices which can be used to activate Mobile
Lite to make emergency report.
Entering Learning Mode
Press the Active Button of Mobile Lite for 8 seconds. Mobile Lite will emit one
beep at 5
th
and 8
th
second. Release the button after the beep at 8
th
second to
enter learning mode.
Device Learning and Testing
Step 1. Press the Button on RF device to transmit signal. Refer to RF device
manual for detail.
Step 2. Mobile Lite will emit 2 beeps when it receives the signal from the
pendant to indicate it has learned in the pendant.
Step 3. Repeat Step 2~3 to learn in all devices, device learnt in will be assign
from Zone 1 to 5 in sequence.
If Mobile Lite has already learnt in 5 devices, it will emit 3 beeps upon
receiving a new device learn code to indicate error.
To test learnt in device, press the device button again after learning,
Mobile Lite will emit a long beep if it successfully receives signal from
already learnt in device.
After complete learning, press the Active Button on Mobile Lite once to
exit learning mode. Mobile Lite will emit 2 beeps
Device Removal
Press Mobile Lite Active Button twice quickly under learning mode, Mobile Lite
will emit two beeps to indicate ALL RF devices have been removed and exit
learn mode automatically.