Climax Mobile Pro - Alarm Activation

40
minutes.
 If the user leaves the GeoFence area and is detected while Mobile Lite is
checking its location, it will automatically report to the report destinations.
 If the user returns to the GeoFence area, it will also send restoration
report to the report destinations.
 When Mobile Lite makes a second low battery report to the CMS, the GPS
function is turned off and GeoFence function will be turned off.
6.5. Alarm Activation
 When the user presses the Active Button of Mobile Lite or the learnt-in RF
device (WTR, Fall Sensor or PB) for help, Mobile Lite will emit a voice
prompt “Emergency Call was pressed” as it enters guard time.
 When a fall is detected from the learnt-in Fall Sensor, Mobile Lite will enter
guard time.
 If Mobile Lite is activated while having a cellular network fault (Amber LED
flashes once every 3 seconds), it will emit 3 beeps as a local warning.
 If there are no report destinations programmed, Mobile Lite will not report
upon alarm activation and will emit 1 beep as a reminder.
 Mobile Lite will also report its destination along with the alarm report
(please refer to 6.3. Locating Mobile Lite) provided the programmed
report method(s) supports location report.
Guard Time
 After Mobile Lite is activated, it will begin counting down the Guard Time
and begin reporting after Guard Time has expired. Mobile Lite will
continuously play voice prompt “Help call in progress” during guard time.
 During guard time, the user can cancel the alarm reporting by pressing the
Active Button of Mobile Lite for 5 seconds or pressing the Active Button of
the learnt-in RF device for a duration determined by the device (please
refer to the device user manual). If alarm is canceled, Mobile Lite will play
voice prompt “Help call cancelled”.
 Alarm cannot be cancelled after guard time has expired.
Confirmation Beeps
 After guard time expires, Mobile Lite will summon help based on the
programmed reporting methods. When Mobile Lite is reporting, it will emit
confirmation beeps (1 beep every second).
 For Speech Reporting, if the call recipient picks up the call, Mobile Lite will
stop beeping. It will start emitting confirmation beeps again when reporting
is resumed (e.g. report to the next report destination).
Last GPS Location