Climax Mobile Pro - Operation

38
6. Operation
6.1. Answering Incoming Calls
 Mobile Lite will ring when there is an incoming call.
 The user can press Mobile Lite’s Active Button or the learnt-in RF device
(WTR, Fall Sensor or PB) button to pick up the call.
 If “Answer Incoming Calls” is set as Enable(Auto-Answer), Mobile Lite will
auto-answer an incoming call after the first ring, and depending on the
setting of “Incoming all Check Access Code”, Mobile Lite will check the
Access Code or not before it opens a full-duplex Two-way communication.
(Pease see 4.1.6. Setting)
 If the number of the incoming call matches any of the Caller ID, Mobile
Lite will instantly pick up the call (without checking Access Code).
 Press a DTMF key for over 1 second to enable a designed shortcut
function.
- Enter (1) to talk only.
- Enter (2) to open two-way voice communication.
- Enter (3) to listen in only.
- Enter (9) to hang up. You can also put the handset back to the base
cradle to end the call.
 Press Mobile Lite’s Active Button for 5 seconds or press the learnt-in RF
device (WTR, Fall Sensor or PB) button once to hang up.
 The caller can press either DTMF (9) key, Active Button of RF device, or
put the handset back to the base cradle to hang up.
 Pressing any DTMF (except DTMF 9) can reset the communication time
to the preset duration.
<
<
N
N
O
O
T
T
E
E
>
>
 The function of pressing sensor button to end call is now programmable
via PC Programming Tool or SMS command. Default is disabled
6.2. Current Operation Condition
Mobile Lite uses its LED to remind the user of its Current Operation Condition.
 LED indicators:
Case B
LED
Behavior
Indication
Green LED (Top LED)
On
Mobile Lite is being charged.