Climax Mobile Pro - Csv Ip

59
- P… stands for the margin of cell location error in meters (the
parameter will show a 0 if the location data was identified using
GPS).
- b:…% stands for the battery level (100%, 90%, 80%, 70%, 60%, 50%,
40%, 30%, 20%, 10%)
- d:… means if Mobile Pro is placed on the base slot (0 = not placed, 1
= placed)
- g:… stands for the Cellular signal strength (level: 1-5, where 5 =
strongest signal strength and 1 = weakest signal strength)
- t:…stands for the timestamp in UTC when the location was acquired.
- la:…means if it’s last GPS location or current GPS location (0 =
current GPS location, 1 = last GPS location)
- c:… stands for the charging status (0 = not charging, 1 = charging)
8.4. CSV IP
The message composition for CSV IP reporting includes username and
password before the message.
The form of the message is similar to CID reporting, please refer to 7.2.
Contact ID Communications Protocol and Format.
 100 – Mobile Lite Emergency (emergency)
 When the Active Button of Mobile Lite is pressed (“Help Event” set as
100).
 101 – Personal Emergency (emergency)
 When the Active Button of Mobile Lite is pressed (“Help Event” set as
101).
 When the Active Button of the learnt-in Fall Sensor, WTR or Panic
Button is pressed.
 102 – Inactivity (emergency)
 When a Fall Sensor remains stationary for 10 seconds after fall
detection.
 120 – Fall Detection / Panic (emergency)
 When a fall is detected from the learnt-in Fall Sensor.
 When the Active Button of Mobile Lite is pressed (“Help Event” set as
120).
 301 – AC Fail/Restore (status)
 When AC is disconnected (fail)