Climax Mobile Pro - Speech Reporting Method

45
 If the number of the incoming call matches any of the Caller ID, Mobile
Lite will instantly pick up the call, emit one beep (at the caller handset) and
open a two-way communication (without checking Access Code).
 The caller can call back multiple times during the callback period.
 The caller can use the following DTMF commands to control the call:
- Enter (1) for talk-only mode.
- Enter (2) for two-way voice communication.
- Enter (3) for listen-in only mode.
- Enter (9) to hang up.
- Put the handset back to the base cradle to end the call.
- Press and hold the Active Button of Mobile Lite for 5 seconds, or press
Active Button of RF device (WTR, Fall Sensor or PB) once to end the
call.
- Press any DTMF key except for the designated hang-up key (9) to
reset the communication time to its preset duration. When a DTMF key
is pressed, its designed shortcut function will also be executed along
with the communication time reset.
<
<
N
N
O
O
T
T
E
E
>
>
 If you wish to enable a designed shortcut function, please press the DTMF
key for at least 1 second.
 The function of pressing sensor button to end call is now programmable
via PC Programming Tool or SMS command. Default is disabled.
6.5.3. Speech Reporting Method
 If speech reporting method is selected, Mobile Lite will dial the
programmed number for reporting. It will establish a two-way voice
communication between the call recipient and Mobile Lite user.
 If Mobile Silent is enabled on Mobile Lite, a Listen-In only communication
will be established instead.
 The CMS can remotely control Mobile Lite during the voice
communication period using the DTMF commands below:
- Enter (1) for talk-only mode.
- Enter (2) for two-way voice communication.
- Enter (3) for listen-in only mode.
- Enter (9) to hang up.
- Put the handset back to the base cradle to end the call.
- Press and hold the Active Button of Mobile Lite for 5 seconds, or press
the Active Button of RF device (WTR, Fall Sensor or PB) once to end
the call.
- Press any DTMF key except for the designated hang-up key (9) to
reset the communication time to its preset duration. When a DTMF key
is pressed, its designed shortcut function will also be executed along