HCS User Manual
20
HCS EVSE Mounting for Solid-Wall Construction
• To secure the unit in concrete, pre-drill appropriately sized
holes and use multi-set or wedge anchor hardware at both
mounting points.
• To secure the unit in brick or stone, pre-drill appropriately
sized holes and use sleeve anchors at both mounting points.
• The included plastic angle washers can be oriented to allow
bolts to be fastened either at an angle or perpendicular to
the mounting surface. NOTE there are two different sets of
plastic angle washers included. Select those washers that best
accommodate the mounting hardware “angle of attack” and
orient them accordingly.
•
• NOTE that if the head of the mounting hardware is smaller
washer will need to be placed between the plastic angle washer
and the mounting hardware.
• Machine screw size ¼”-20 hardware is recommended
for mounting the HCS. Screw shafts of at least 2” are
diameter, ensure the screw heads are of a larger diameter. Place
appropriately sized washers between the screw heads and the
To Next Page
Loading...
