HCS User Manual
38
COSMOS
®
Load Management Enabled HCS
The COSMOS
®
option is a Load Management Access Point which
can be connected to a third party load management monitoring and
and promote energy conservation.
The COSMOS
®
Load Management Enabled HCS provides two
ways to control energy usage:
1. The Digital Interface
2. The Serial Interface (if the Serial Interface is used it
will take precedence over the Digital Interface)
COSMOS
®
Wiring Instructions
1. Determine whether the Digital Interface will be used
with or without the Serial Interface in the installation.
NOTE:
Contact ClipperCreek to obtain an NDA for
documentation describing the Communication Protocol
for the Serial Interface.
3. Connect the appropriate interface wires to the desired
controller. Please refer to Table 4.
To Next Page
Loading...
