HCS User Manual
29
Contact a Customer Service Representative at (877) 694-4194 for
additional information. Installation instructions for each expanded
functionality follow.
ChargeGuard
®
Enabled HCS
ChargeGuard
®
is a built-in key based access control option. Refer
to these instructions to operate a ChargeGuard
®
enabled HCS
EVSE.
1. Connect the HCS EVSE to the vehicle with the
SAE-J1772
TM
connector.
2. To enable charging:
a) Insert the key into the switch located on the right side
of the HCS EVSE.
b) Turn the key 90° clockwise to the vertical position as
shown in the Figure 12.
c) The “CHARGING” LED light will illuminate green on
the front panel, indicating the vehicle is now being
charged.
3. To allow charging of Multiple Vehicles:
a) Leave the key in the present vertical position.
This allows disconnection of the EVSE from one
vehicle and reconnection to the same or another vehicle
without moving the key.
b) The EVSE will be enabled and power will be available
to vehicles as long as the key remains in the vertical
position.
NOTE:
The key cannot be removed in the vertical position. See
Step 4 for key removal instructions.
To Next Page
Loading...
