of 5020
2. Open Door Alert Function
a. Perform door open test – Open door during infusion and verify alarm.
b. Open door alert test is passed if alert activates when door is opened.
3. Air Detect Function
a. Load a primed BodyGuard tubing set into pump.
b. Attach a y-site upstream of the pump.
c. Using a 3 ml syringe, inject 1.1 ml of air into the line - alarm should
activate once the air bubble passes the sensor. This test will demonstrate
the accumulation of air bubbles of 1 ml over 15 minutes (user should
check Air Limit is set to 1ml under ‘Change Set Up’).
d. Test is passed if air alarm activates under 1 ml.
4. Battery Operation Test
a. Discharge battery to “End Battery”.
b. Charge battery until green charge indicator light turns on.
c. Program pump to 1200ml/hr.
d. Start pump and start timer and run to “End Battery”.
e. Record time to discharge pump.
f. If battery ran for at least 3 hours, battery passes, if battery did not,
replace battery.
5. Restore Software Default Settings (page 46)
a. Check software default settings are restored. (User programmable
protocols should be blank)
b. Test is passed if they are set to Software default values.
Note: Complaint pumps will have software default settings restored after
notification of complaint closure.
c. Check that Software Default Settings were restored
d. Software default settings should only be restored before beginning the
last Operational Checklist and Performance Acceptance Test after service
has been completed.
6. Pole Mount Charger Voltage Test (page 35)
a. Using voltmeter, measure pin voltages diagrammed in section 1.3
Replacing Charger PCB
To Next Page
Loading...
Need help?
General
