CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
2.6.1 Desc ription of th e i nstal l ed sa f e t y ins t a llati o ns
Fig.1: Emergency-stop-button
By pressing the emergency-stop-button (Fig. 1) the machine is shut down by immediately switching
off the energy supply to the machine drives. After pressing the emergency-off-button, it has to be
turned to be able to turn the machine on again.
WARNING:
Danger to life when unintentional switching the machine back on!
Unintentional start-up of the machine can lead to severe injuries and death.
• Before switching on the machine make sure, that the cause of the
emergency-stop is eliminated and all safety installations are correctly
installed and functional.
• Only unlock the emergency-stop-button (Fig. 2 u. 3) when there is no risk.
Position of emergency-stop-button
Fig. 2: Emergency stop button
machine front
Fig. 3: Emergency Stop button on the stepper motor
controller (accessory)
To Next Page
Loading...
