CNC-Step T-Rex Series - Transport

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 43
Support: +49 (0)2831/91021-50
31.03.2014
5.5 Transport
Sling points
The machine may only be transported and slinged in the frame.
Transport of pallets with the crane
Transport pieces, which are fastened on a pallet can be transported by a crane under the following
conditions:
• Crane and lifting gear must be designed for the weight of the transported items.
• The operator must be authorised to operate the crane.
Slinging
protective equipment:
• Industrial safety helmet
Fig. 20: lifting gear
1
Sling on ropes, belts accordingly (Fig. 20) to the pallet and
secure pallet against slipping.
2
Check whether the transport pieces are not damaged by the
slinging materials. If necessary, use other slings.
3
Make sure that the pallet with off-centre gravity cannot tip.
4
Start the transport.
Transport of pallets with a forklift
Transport pieces, which are attached to pallets can be transported under the following conditions
using a forklift:
• The fork lift must be rated for the weight of the transport pieces.
• The transport package shall be securely fastened on the pallet.
• The folk lift driver must be authorized to drive industrial trucks with driver's seat or driver's
cab according to national regulations.