CNC-Step T-Rex Series - Storage

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 44
Support: +49 (0)2831/91021-50
31.03.2014
Transport
Fig. 21: Transportation by forklift
1
Drive the forklift with the forks between or the holms of
the pallet.
2
Drive the forks so far that they protrude on the opposite
side.
3
Make sure that the pallet with off-centre gravity cannot tilt.
4
Lift the pallet with transport piece and start the transport.
5.6 Storage
Storage of packages
Packages should be stored under the following conditions:
• Do not store outdoors.
• Dry and dust free.
• Not exposed to corrosive media.
• Protect from sunlight.
• Avoid mechanical shocks.
• Storage temperature: 10 to 35 ° C.
• Relative humidity: max. 60%.
For storage longer than 3 months regularly check the general condition of all parts and packaging. If
necessary, refresh or renew the preservative.
HINT:
Further instructions for storage may be found on the packaging, which go beyond
the requirements listed here. These comply accordingly.