CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
6 Installation and commissioning
6.1 Safety instructions for the installation and commissioning
Suspended loads
WARNING:
Danger to life due to suspended loads!
When lifting, loads can swing out and fall off. This may lead to serious injury or
death.
• Never stand under or into the swivel area of a suspended load.
• Loads are only to be moved only under supervision.
• Use only approved lifting gear and lifting gear with sufficient load-bearing
capacity.
• Do not use damaged or frayed lifting equipment such as ropes and straps.
• Lifting equipment such as ropes and straps must not be laid on sharp edges
and corners do not twist or knot.
• When leaving the workplace settle the load.
Improper installation and commissioning
WARNING:
Risk of injury by improper installation and commissioning!
Improper installation and commissioning can lead to severe injuries and substantial
property damage.
• Before starting any work sufficient installation freedom is required.
• Handle open, sharp-edged components with care.
• Maintain order and cleanliness at the installation site! Loosely stacked or
scattered components and tools are accident sources.
• Install components professionally. Comply with the specified screw
tightening torques.
• Secure components so they do not fall down or fall over.
• Note following guidelines before commissioning:
Ensure that all installation work in accordance with the information and
instructions were carried out and completed in this guide. Ensure that there are
no persons in the danger zone.
To Next Page
Loading...
