CNC-Step T-Rex Series - Preparations; Install Machine

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 46
Support: +49 (0)2831/91021-50
31.03.2014
Screw tightening torques
HINT:
Property damage caused by incorrect screw tightening torques!
All screws on the machine have been tightened before delivery to the appropriate
torque.
Additional tightening leads to undesired tensions in the machine and thus to
inaccurate machining of the work pieces.
• Tighten No screws on the machine!
6.2 Preparations
6.2.1 Ins t a ll ma c h i ne
Personnel:
• Specialist personnel
Safety equipment:
• Protective clothing
• Safety shoes
• Industrial protective helmet
ATTENTION:
Risk of injury by under-sized buildings!
Overload of ceiling structures can lead to serious damage and personal injury!
• If the machine is situated on a cantilevered building ceiling, note the
dynamic loads due to the movements.
Uneven ground
HINT:
Material damage caused by uneven ground!
Due to uneven ground deformations are caused within the machine. This results in
an imprecise machining of the work pieces.
• Place the machine on a flat and level surface.
1. Place the machine on a level, vibration-resistant surface.
2. horizontal align (Utilities water balance).