CNC-Step T-Rex Series - Switching On

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 52
Support: +49 (0)2831/91021-50
31.03.2014
7.3 Switching on
Personnel:
Operator
1
Turn on the computer and boot the software.
2
Clamp work piece
3
Ensure that required tool is in the tool holder, if necessary, change the tool, and see the separate
operating instructions for the accessories.
4
Ensure that no tools or other foreign objects are in the machine or system.
5
Make sure that no persons are in the danger zone.
6
Connect required accessories to the provided power supply.
7
Switch on the stepper motor control; refer to the separate operating instructions for the step
motor control.
8
Perform reference run.
9
10
Zero point determination.
Start Job.