CNC-Step T-Rex Series - Lubricate Machine

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 62
Support: +49 (0)2831/91021-50
31.03.2014
8.4.2 Lubri cate ma chin e
The lubricants reduce wear, protect against pollution, reduce corrosion and prolong the service life
by their properties.
For supplies, see chapter 3.4.
Oil linear guides
Personnel:
• Qualified personnel
Safety equipment:
• protective clothing
• Safety shoes
• Chemical-resistant gloves
Fig. 29: linear guides of the X-
axis
1
2
Switch off the machine and secure against re-start.
Grease the linear guides of the X-axis (Fig. 29/1), the Z-axis well
using a low-friction grease wetted cloth DIN 61650 or
alternatively apply the fat with a suitable brush.
Fig. 30: Linear guide of the Y-axis
3
Grease the linear guides of the X-axis (Fig. 30/1) well using
low-friction grease soaked cloth DIN 61650 or alternatively
apply the grease with a suitable brush.
1
1