CNC-Step T-Rex Series - Cancel the Emergency Stop

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 70
Support: +49 (0)2831/91021-50
31.03.2014
9.3 Problem resolution
9.3.1 Canc e l the e merg e ncy s top
Personnel:
• Operator
Fig. 34: Emergency stop button
1 Determine and remedy the fault cause.
2 Unlock the emergency stop button by turning (Fig. 34)
twice.
9.4 Commissioning after fault has been rectified
Perform the following steps to restart after correcting the fault:
1
Reset the emergency stop devices.
2
Acknowledge the fault of the control.
3
Make sure, that nobody is sure no persons in the danger zone.
4
Start according to the instructions in chapter "Operation".