CNC-Step T-Rex Series - Page 69

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 69
Support: +49 (0)2831/91021-50
31.03.2014
If a disorder in the fault table is not included, please contact Customer Service. See
the separate operating instructions regarding the correcting of fault of the supplied
components.
Machine travels a
short distance and
stops abruptly
USB dongle is not
inserted properly or not
at all
Check the USB dongle
for correct fit
Operator
Machine jammed and
cannot be moved
Lack of care and
maintenance
Clean, re-lubricate if
necessary repair by
manufacturer
Operator /
manufacturer
Machine does not
recognize the reference
switch
Feed homing in software
incorrectly set
Set guideline 5mm/sec in
software
qualified
personnel
Reference switch is
defective
Replacement or repair
Personnel /
Manufacturer