CNC-Step T-Rex Series - Tool Holder; Operating Elements

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 36
Support: +49 (0)2831/91021-50
31.03.2014
4.3.4 Too l hold er
Fig. 16: Tool holder 43H7
On the tool holder of the Z-axis (Fig. 16/1)some of the most
important tools, optionally available, can be attached(see
Appendix "Accessories").
4.4 Operating elements
The machine does not have its own controls for moving the axes. This is only possible using
separate interfaces (e.g. stepper motor control Zero3)
1