CNC-Step T-Rex Series - Change Tool; Switching off

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 56
Support: +49 (0)2831/91021-50
31.03.2014
7.4.2 Chang e t o o l
Personnel:
• Operator
Safety equipment:
• protective clothing
• Safety shoes
• protective gloves
1
Make sure that the tool (e.g. milling motor, tangential knife, etc.) is de-energized
(Connecting cable, pull out the mains plug or power button press)
ATTENTION:
Risk of burns from hot surfaces! Risk of being cut by tools and chips!
Contact with hot components can cause burns. Tools and chippings can cause injury
when touched.
- When changing tools, wear protective gloves.
2
Change tool, see the separate operating and assembly instructions
3
Make sure that the tool is again provided with voltage (connection cable, connect the power
plug or switch power button)
7.5 Switching off
1
Turn power switch on the stepper motor control to "0" or "Off"; see separate operating
instructions for the step motor control.
2
Stop software for the machine on the computer.
3
Shut down computer.