CNC-Step T-Rex Series - Initial Start-up

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 50
Support: +49 (0)2831/91021-50
31.03.2014
6.4 Initial start-up
Personnel:
• Specialist personnel
1
Make sure that the machine is installed and aligned.
2
Ensure that the stepper motor, and control lines are connected to the stepper motor controller
3
Make sure that the computer is connected to the stepper motor control of the machine.
4
Ensure that required accessory is installed and connected to the power supply.
5
Ensure that the appropriate software is installed on the PC.
6
Ensure the tightness of all connections.
HINT:
The individual materials have different coefficients of expansion. At an ambient
temperature of 20-25 ° C it is ensured that no significant impacts occur during
processing. Therefore, it is recommended to maintain an ambient temperature of 20-
25 ° C when operating the machine.