CNC-Step T-Rex Series - Page 64

Operating Instructions
T-Rex-Series
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 64
Support: +49 (0)2831/91021-50
31.03.2014
Fig. 32: X-drive
1
Switch off the machine and secure against restarting.
2
Ball screw (below the machine table).
Grease ball screw spindle (Fig. 32/1) with a low-friction
grease applied on a cleaning cloth DIN 61650 or alternatively
apply the grease with a suitable brush.
Fig. 33: Y-drive bellows open
3
Ball screw
Grease ball screw (Fig. 33/1) with a low-friction grease
applied on a cleaning cloth DIN 61650 or alternatively apply
the grease with a suitable brush.
Fig. 34: Z-drive bellows open
4
Ball screw
Grease ball screw (Fig. 32/1) with a low-friction grease
applied on a cleaning cloth DIN 61650 or alternatively apply
the grease with a suitable brush.
ATTENTION:
Risk of health damage by contact with oil and grease!
Contact with oil and fat can lead to health damage.
• Avoid skin contact.
• Remove Oil and grease immediately from the skin.
• Do not inhale vapours.
1
1
1