coaxLAN CL64WLAN - Page 25

CL64WLAN User Manual V001
25 of 44
Item
Description
WIFI
There are two options in this combo box:
• Enable: to enable WiFi interface of the CL64WLAN.
•
Disable: to disable WiFi interface of the CL64WLAN
Channel Selection
This combo box allows to set the operating channel
manually by selecting a channel from the channel
selection list or to use
the auto channel selection
option (auto) to have it automatically configured.
Model
It is the wireless mode used. The available values
shown by the related check box are:
• auto
• 11B: 802.11 b
• 11G: 802.11 g
• 11NGHT20: 802.11 n/g HT20
• 11NGHT40PLUS: 802.11 n/g HT40plus
• 11NGHT40MINUS: 802.11 n/g HT40minus
The default mode is 11NGHT40PLUS (up to 145 Mbps).
Country
It is the country where the slave is installed. The combo
box shows the list of available countries.
Note: it might
be illegal to operate the slave in
a region other than
the countries listed.
Transmitting power
It is the level of power emitted by the slave WiFi
interface. From 20% to 100%, in steps of 20%. 100%
means maximum power.
Set SSID number
You can set up to 4 SSID. Default value is 1.
Table 7