Appendix 3: Operation
98-143082-D To access the terminal from a remote location (BGAN only) 25
To use AT commands to get remote access to the web interface
You can send the AT commands encapsulated in an SMS (ATCO commands). For details, see
Prepare the terminal for remote access with SMS on page 74.
Relevant command:
_IREMWEB
See ATCO commands on page 109 for syntax and parameters.
1. To use an SMS to allow access to the web interface for specific IP addresses, send the
following command:
ATCO <resp_mode> <rsms_pwd> _IREMWEB=1,<ip address>[,<ip address>]
Example: ATCO 2 remote _IREMWEB=1, 214.123.189.119
In this example the command specifies no immediate response, only when the global IP
address is sent along (2). The remote SMS password is remote and the IP address
214.123.189.119 can get remote access to the web interface (if two IP addresses are
listed, it is interpreted as a range of IP addresses).
2. The EXPLORER 510 should now return an SMS response with the external IP address of the
terminal.
Example: _IREMWEB:81, GlobalIP:161.30.181.31
81 is the response code for a remote web connection that was set up successfully. It is
followed by the global IP address, which is the IP address to enter in your browser to
access the web interface from the remote device with the IP address you specified in the
command.
3. On the remote computer, open your web browser.
4. In the address bar of your browser, enter the global IP address of the EXPLORER 510
(received in the response above).
You should now be connected to the built-in web interface of the terminal.
To get remote access from a trusted IP address (preconfigured)
Initial local configuration:
1. Connect a computer to the EXPLORER 510 and access the web interface locally.
If remote SMS command access has been disabled, you can enable it either using the
web interface (Prepare the terminal for remote access with SMS on page 74) or
using the AT command _ISMSRMT (see Other M2M related AT commands on
page 113). Note that you must have configured at least one trusted phone
number that can send and receive SMS to and from the terminal.
This method requires that you initially have local access to the EXPLORER 510. If not,
use the _IREMWEB command described in the previous section.
To Next Page
Loading...
