Chapter 4: To use the web interface
98-140012-H Advanced settings 103
Remote control of tracking
When you are using the tracking function of the EXPLORER 710, you can set up the terminal so
that the tracking server can access the EXPLORER 710 e.g. to start or stop tracking or to change
reporting intervals.
To allow the tracking server to control the tracking settings, do as follows:
1. Under Advanced, select Tracking settings.
2. Select Allow remote control of tracking.
3. Click Save.
The EXPLORER terminal will now accept commands from the specified tracking server, for
example to change reporting intervals or start/stop reporting.
To Next Page
Loading...
