COBHAM Explorer 710 - Page 164

Appendix B: Command reference
98-140012-H AT commands 155
Other M2M related AT commands
Parameters for other M2M related AT commands
The table below summarizes the available parameters for the AT commands for M2M
operation.
Command Parameters
_ICLCK
<type>,<enable>,<passwd>
_IMACLOC
<enable>,<interface>[,<interface>]
_IMACLOCAD
<action>,<interface>,<MAC Address>[,<MAC Address>]
a
_ISMSRMT
<enable>
_ITDCIV
No parameters
b
a. Up to 10 MAC addresses may be specified.
b. Type _ITDCIV? to get the input voltage (in mV) of the EXPLORER 710
Parameter Values Meaning
<action> 0
1
Delete.
Add.
<enable> 0
1
Disable.
Enable.
<interface> 0 0 means Ethernet interface. This is the only option.
<MAC Address> <MAC Address> MAC address(es) for MAC locking. Up to 10 MAC addresses are permitted.
<passwd> <passwd> The existing administrator password.