Chapter 2: To get started
98-140012-H To connect your phone to the EXPLORER 710 23
To connect a wired IP handset for making calls
For details on initial setup of your IP handset and the EXPLORER 710, see
• The documentation for your handset
• First time SIP setup on page 23
• To manage IP handsets or smartphones on page 68
To connect a wired IP handset, do as follows:
1. Start up the EXPLORER 710 terminal.
2. Connect the LAN cable between the IP handset and the connector LAN #1 on the
EXPLORER 710.
When the IP handset is powered and ready, you should now be able to make and receive calls
over BGAN.
First time SIP setup
If you do not have a Thrane IP Handset nor a phone with the EXPLORER Connect app and it is
the first time you connect your phone to the LAN or WLAN interface for making calls, you must
first set up the SIP server details in your smartphone. For information how, see the user
documentation for your smartphone and for the SIP application. You may be asked to enter
some of the following details:
• SIP server address and port: Default address: 192.168.0.1, Port: 5060
• User name: Local no. in EXPLORER 710 (0501 to 0516)
• Password: Default same as user name
• Codec priority: Highest priority codec type: G.711
Make sure your IP handset complies with PoE class 2 (7 W).
If you are using a Thrane IP Handset and have enabled support for it, no initial
configuration is necessary.
Make sure PoE is enabled in the terminal. See LAN interface setup on page 63.
The user name and password must match the IP handset settings in the web interface
of the EXPLORER 710. See To manage IP handsets or smartphones on page 68.
To Next Page
Loading...
