Chapter 4: To use the web interface
98-140012-H To set up the interfaces 65
ISDN interface setup
To configure the ISDN interface, do as follows:
1. In the Control panel
, click the ISDN icon at the top of the page.
2. Click the ISDN number you want to change settings for.
3. To enable the ISDN interface, select Enable (all ISDN devices).
4. Set the call type for incoming calls.
You can select Standard voice, 3.1 kHz audio, UDI and/or RDI.
An incoming call to the ISDN interface will only make the connected device ring if the call
type used for the call is selected here.
5. Click Save.
• A line through a grayed-out ISDN icon means the interface is disabled.
• A blue ISDN icon means the interface is enabled.
USB interface setup
Note that the USB interface is a Host interface, primarily used for charging smartphones, for
recovery software upload or for connecting an EXPLORER cellular modem.
To configure the USB interface, do as follows:
1. In the Control panel
, click the USB icon at the top of the page.
2. To enable the USB interface, select Enable.
3. Select the Charge current.
Select 0.5 A or 2.0 A, depending on the specifications for the device you are going to
connect.
4. Click Save.
• A line through a grayed-out USB icon means the interface is disabled.
• A blue USB icon means the interface is enabled.
It may take some seconds to enable the interface.
It may take some seconds to enable and disable the interface.
To Next Page
Loading...
