21 | P a g e
2. Manual Frame-Moving:
• When the machine stops, press direction keys to move frame along the
corresponding direction. Press the two neighboring keys at the same time to move the frame in
the direction of the angle bisector. is the speed key for manual frame-moving. Press to
shift between (high speed) and (low speed).
3. Clear the Frame Coordinates
• When the machine stops, press to clear the XY displacements displayed in the main
interface. The function can be used with manual frame-moving.
4. Manual Color-Changing
• When the machine stops, press in the main interface to enter manual color-changing
interface. Then click the needle number for color-changing, and the machine head will
automatically move to the corresponding needle position.
• Please note: if the user wants to automatically save the order of the manual color-changing, user
should operate it in the manual color-changing interface on the touch screen.
5. Adjust Main Shaft Manually
• Usually, the main shaft needs to stop at 100° at needle/color-changing, frame-moving and
beginning embroidery. User can manually turn the main shaft to 100° when it hasn’t reached
there. Press in the main interface to carry out this function.
• After the operation, (not in position) will changing into (in position).
6. Back to Origin
• Press in the main interface to enter idling interface, where user can press to return
the frame to origin.
7. Back to Stop Point
• Press in the main interface to enter idling interface, where user can press to return
the frame to stop point.
8. Positioned Idling
• Use this function after embroidery confirmation. Positioned idling enables the machine to move
to the appointed position without embroidering according to the user’s requests. Press to
set idling backward or forward at the color-changing code or stop code by one stitch or
continuously.
To Next Page
Loading...