COMAC Abila 45B - Recharging the Batteries with Built-In Battery Charger (Versions with Bc)

13
MACHINE PREPARATION
7. Disconnect the electrical system connector from the battery connector (2)
8. Connect the battery charger cable connector
The coupling connector of the battery charger is consigned inside the bag containing this instruction
booklet, and must be assembled on the cables of the battery charger as indicated in the instructions.
ATTENTION: This process must be carried out by qualified personnel. An
incorrect connection of the connector may cause problems with machine
functioning.
2
9. Connect the recently wired cable to the external battery charger
ATTENTION: Carefully read the use and maintenance instructions of the
battery charger that is used for charging.
ATTENTION: Keep the recovery tank open for the duration of the battery
recharging cycle to allow gas fumes to escape
10. After the charging cycle is complete, the battery connector (2) must be connected to the
electrical system connector
ATTENTION: danger of gas exhalation and leakage of corrosive liquids.
ATTENTION: danger of fire: do not go near with free flames
10. RECHARGING THE BATTERIES WITH BUILT-IN BATTERY CHARGER (VERSIONS WITH BC)
The machine is shipped with the battery connector (if supplied) disconnected, connect the battery
connector to the machine connector (see previous paragraph).
To charge the gel battery proceed as follows:
1. Engage the parking brake.
2. Check that the machine's master switch is in the "0" position.
3. Lift the battery charger socket guard (1) on the back of the machine.
4. Plug the battery charger cable into the electrical system of the machine.
5. Plug the power supply cable of the charger into the mains socket.
To charge the lead acid batteries proceed as follows:
1. Engage the parking brake.
2. Check that the machine's master switch is in the "0" position.
3. Lower the brush head by means of the pedal on the back of the machine
4. Lower the squeegee by means of the lever on the back of the machine
5. Check the recovery tank is empty, otherwise empty it (see the appropriate chapter)
6. release the hinges (1) on the handlebars.
7. Rotate the tank as far as it will go, using the side handle (2).
1
2
1