AT THE END OF THE WORK
1. AT THE END OF WORK
At the end of the work, and before carrying out any type of maintenance:
1. Turn the key of the master switch to the "0" position and then immediately to the "1" position, this will
disable the suction motor.
2. Raise the squeegee by turning the lever at the rear of the machine clockwise.
3. Raise the brush head by levering the appropriate pedal with the foot.
4. Take the machine in an area designated for the disposal of liquids.
5. Turn the key of the master switch to the "0" position, and remove the key, for the electric versions
disconnect the plug from the mains socket.
6. Engage the parking brake, by means of the lever on the side of the machine.
7. Disconnect the pipe from its hook, unscrew the discharge plug and empty the recovery tank.
To simplify the draining operation, you are advised to keep the tube bent with one hand and, with the
other, unscrew the knob and remove the plug.
Slowly straighten the tube and the liquid will start draining at the desired speed.
ATTENTION: This operation must be carried out using gloves to protect against
contact with dangerous solutions
8. Disassemble the brushes and clean them with a jet of water (to disassemble the brushes, see
“DISASSEMBLING THE BRUSHES” below).
9. At the end of the work, park the machine in a closed place.
10. Engage the parking brake.
Do not leave the squeegee and brush head resting on the floor for a long time.
ATTENTION: do not leave the machine unattended without first removing the
start-up switch key and applying the parking brake. In addition, do not park the
machine in open places or on sloping floors.
2. STORING OF THE MACHINE
Proceed as follows to store the machine at the end of work:
1. Place the machine in a place where it can not cause damage or injury
2. Position the machine where the accidental fall of objects do not cause damage
3. Engage the parking brake
4. Turn the key switch to the “0” position
5. Disconnect the machine connector
6. Lift the brush head and squeegee
To Next Page
Loading...
