CHOOSING AND USING THE BRUSHES
POLYPROPYLENE BRUSH (PPL)
Used on all types of floor, it has good resistance to wear and tear and hot water (no greater than 60°C). PPL is non-hygroscopic and therefore retains its
characteristics even when working in wet conditions.
ABRASIVE BRUSH
The bristles of this type of brush are charged with highly aggressive abrasives. It is used to clean very dirty floors. To avoid floor damage, work only with the
pressure strictly necessary.
THICKNESS OF THE BRISTLES
Thicker bristles are more rigid and are therefore used on smooth floors or floors with small joints.
On uneven floors or those with deep joints, it is advisable to use softer bristles which can enter the gaps more easily.
Remember that when the bristles are worn and therefore too short, they will become rigid and are no longer able to penetrate and clean deep down. In this
case, like with overlarge bristles, the brush tends to jump.
PAD HOLDER
The pad holder is recommended for cleaning shiny surfaces.
There are two types of pad holder:
1. the traditional pad holder is fitted with a series of anchor points that allow the abrasive floor pad to be held and dragged while working.
2. the CENTRE LOCK type pad holder not only has anchor points, but also a snap-type central locking system in plastic that allows the abrasive floor pad
to be perfectly centred and held without any risk of it becoming detached. This type of dragging device is recommended above all for machines with
more than one brush, where the centring of the abrasive discs is difficult.
TABLE FOR CHOOSING THE BRUSHES
Machine No. of brushes. Code Type of bristles
Bristles Brush.
Length. Notes
405644 0.3 LIGHT BLUE
405659 0.45
Abila 2010 50B-BT 1 405542 PAD HOLDER D=500 500 61
405510 PAD HOLDER D=210 24
Abila 2010 42B-BT 2
405531 PAD HOLDER D=200
200
-
Abila 2010 52B-BT 2 405513 PAD HOLDER D=255 255 -
Abila 2010 45E 1 405540 PAD HOLDER D=430 430 57
Abila 2010 50E 1 405542 PAD HOLDER D=500 500 61
To Next Page
Loading...
