WORK
6. Release the lever (3) and lower the base.
7. Lower the squeegee, turning the lever (4) anticlockwise. The suction motor will start when fully
lowered. To switch off the suction motor, turn the key to position “0” once the work is finished
8. Check the parking brake is released.
9. Adjust the detergent solution coming out to its maximum by using the lever (5) in the rear of the
machine.
10. Turn the speed regulation knob (6) to set the working speed. If the speed is inadequate, the
adjustment knob can be turned even with the machine in motion.
11. Press the dead man's levers (7) to activate the brushes; the machine will begin to move. For the
first few metres, check that the amount of the solution is sufficient to wet the floor, but not so much
that it exits the splash guard, to adjust the flow of the detergent solution coming out read the
sections "DETERGENT SOLUTION REGULATION (VERSIONS WITH WFC WITHOUT CDS)" and
"DETERGENT SOLUTION REGULATION (VERSIONS WITHOUT WFC AND WITH CDS)" and "
DETERGENT SOLUTION REGULATION (VERSIONS WITHOUT WFC AND WITHOUT CDS)".
3. RECOVERY TANK OVERFLOW DEVICE
The machine is equipped with a float which intervenes when the recovery tank is full, which will make the
suction motor sound deeper.
In this case the recovery tank must be emptied.
ATTENTION: This operation must be carried out using gloves to protect
against contact with dangerous solutions.
3
4
7
5
6
To Next Page
Loading...
