WORK
1. PREPARING TO WORK
1. Connect the connector (1) to the batteries (versions without a built-in battery charger), insert the
machine plug into the mains socket for the electric versions.
ATTENTION: before using the machine, the operators must be suitable trained.
We therefore suggest you read this instruction booklet carefully and read it again
whenever difficulties arise while using the machine.
1
2. Rotate the key of the master switch (2) to the "1" position (clockwise). The monitor display on the
instrument panel will immediately come on.
ATTENTION: if the machine is used in places where there is a risk of falling
objects, the operator must be provided with all the appropriate protection devices
as laid out in the legal requirements
3. With switch-on, three consecutive screens are visualised on the monitor. The first screen shows (on
the top line) what type of hour meter has been set; in this case it's a total hour meter (to visualise a
different type - for instance partial - contact the qualified, COMAC-trained personnel). The bottom line
shows the “service” setting (in this case there is no setting).
4. The second screen visualises what battery technology (or mains supply) has been set for machine
operation. In this example, it's lead batteries (to set another type of battery - for instance gel - contact
the qualified, COMAC-trained personnel).
5. The third and last screen (known as “work”) visualises the battery charge status (if it's a battery
supplied machine) and the total functioning time. When the batteries supplied are fully charged, the
upper line contains 8 light indicators that represent a battery. As the batteries gradually run down, the
indicators go out and, with the batteries completely run down, only the battery outline flashes. The
bottom line indicates the hours and minutes of functioning. The flashing “:” symbol indicates that the
hour meter is counting the machine functioning time.
2
To Next Page
Loading...
