WEEKLY MAINTENANCE
6. Turn the wing nuts (4) in the horizontal position
7. Remove the front rubber-pressing blades (5)
8. Remove the rubber (6) and replace it
9. Proceed in reverse to replace the rubber
WARNING: before carrying out any type of maintenance, put the main switch
on “OFF” and disconnect the machine battery connector (battery-operated
version) or disconnect the power supply cable from the mains socket (electric
version).
WARNING: These operations must be carried out using gloves to protect
against contact with dangerous solutions.
If the squeegee rear rubber is worn and does not dry well, it is possible to change the drying edge using
one of the 4 edges of the rubber.
This operation can be done both with a squeegee fitted or removed as follows:
1. Raise the squeegee body by turning the lever anticlockwise.
2. Check that the parking brake is engaged.
3. Remove the suction tube from the squeegee.
4. Turn the handwheel counterclockwise (1) and remove the pin (2) from its housing in the squeegee
coupling.
5. Remove the pin (3) from its housing in the squeegee coupling.
6. Turn the wing nuts (7) in the horizontal position
7. Remove the rear rubber-pressing blades (8)
8. Remove the rubber (9) and replace it
9. adjust the height of the squeegee depending on the rubber (see “ADJUSTING THE HEIGHT OF THE
SQUEEGEE SUPPORT”)
WARNING: Before performing any type of maintenance, turn the main switch
to "OFF" and disconnect the battery connector of the machine (battery
version), disconnect the power cord from the mains socket (electric version).
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions.
4
5
6
1
3
2
7
8
9
To Next Page
Loading...
