ECON-4, SW version 1.4 rev.1, ©ComAp – March 2016 Draft 3
ECON-4 Reference guide.pdf
General guidelines
What describes this manual?
This manual describes usage of ECON-4 for control of engine.
What is a purpose of this manual? This manual provides basic information how to install and operate
ECON-4.
This manual is dedicated for:
Operators of the gen-sets
Gen-set control panel builders
For everybody who is concerned with installation, operation and maintenance of the engines and
gen-sets.
!! Warnings !!
Text
Break Return (Italic) set points
Engine protections (Bold) Set point group
REMOTE START/STOP (Capital letters) binary inputs and outputs
Note:
ComAp believes that all information provided herein is correct and reliable and reserves the right to
update at any time. ComAp does not assume any responsibility for its use unless otherwise expressly
undertaken.
!!! WARNING !!!
Adjust parameters
All parameters are preadjusted to their typical values. But parameters Gear teeth and
Overspeed !!!MUST!!! be adjusted before first start of gen-set.
!!! Wrong adjustment of these parameters can destroy
the engine !!!
!!! The engine must always be equipped by
independent, working and correctly adjusted Overspeed
protection !!!
The following instructions are for qualified personnel only. To avoid personal injury
do not perform any action not specified in this Reference guide !!!
To Next Page
Loading...
Need help?
General
