ComAp IL-NT - Terminals; Address and Jumpers Setting; LED Indication

Accessory Modules for IL-NT, IC-NT, IA-NT and ID-Lite Global Guide
23
4.4.3 Terminals
BINARY INPUTS 8 binary input
ANALOG INPUTS 4analog input
ANALOG OUTPUTS 1 analog output
BINARY OUTPUTS 8 binary output
CAN CAN1 line
RS232-TTL Interface for programming
POWER Power supply
BINARY INPUTS 8 LEDs for binary input indication
BINARY OUTPUTS 8 LEDs for binary output indication
Tx, Rx Indication transmitted or received data
POWER Power supply LED indication
STOP Service jumper
BOOT Programming
RESET Programming/Reset
ID Service jumper
4.4.4 Address and jumpers setting
Programming Firmware
Firmware upgrade is via AT-link (TTL). For programming is necessary to close jumper BOOT. RESET jumper
is used to reset the device. Close jumper to reset the device. For programming is used FlashProg PC tool.
4.4.5 LED indication
Binary inputs
Each binary input has LED which indicates input signal. LED is shining when input signal is set, and LED is
dark while input signal has other state.