Accessory Modules for IL-NT, IC-NT, IA-NT and ID-Lite Global Guide
27
4.5.3 Terminals
BINARY INPUTS 8 binary input
ANALOG INPUTS 4analog input
ANALOG OUTPUTS 1 analog output
BINARY OUTPUTS 8 binary output
CAN CAN1 line
RS232-TTL Interface for programming
POWER Power supply
BINARY INPUTS 8 LEDs for binary input indication
BINARY OUTPUTS 8 LEDs for binary output indication
Tx, Rx Indication transmitted or received data
POWER Power supply LED indication
CAN_R Terminating CAN resistor
RUI Analog inputs configuration
RESET Programming/reset
BOOT Programming
IGS Controller type selection
STOP Service jumper
ADR1
Module’s address offset 1,2
ADR2
Compensation button Long wires resistance compensation
Note: Configuration jumpers IGS, ADR1, ADR2 are OPEN by default.
CAN_R jumper is CLOSE by default (IG-IOM mode).
Analog inputs are configured for resistance measurement by default.
To Next Page
Loading...
