InteliLite Global Guide
332
Setpoint group CM-Ethernet Related FW 1.2.1
Range [units] FIXED / AUTOMATIC [-]
Default value AUTOMATIC Alternative config NO
Step [-]
Comm object 24259 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
The setpoint is used to select the method how the ethernet connection is adjusted.
FIXED:
The ethernet connection is adjusted fixedly according to the setpoints IP Address (page
332), Subnet Mask (page 333), Gateway IP (page 333) and DNS IP Address 1 (page 334).
This option is reccomended for Direct IP connection as the IP address of the device
should be static for this connection type.
AUTOMATIC: The Ethernet connection setting is obtained automatically from the DHCP server. The
obtained settings are visible in the values and the setpoints do not take place. Use this
option if you connect to the device only via AirGate or if you assure obtaining a static IP
address at the DHCP side.
IP Address Mode
6 back to List of setpoints
Setpoint group CM-Ethernet Related FW 1.2.1
Range [units] Valid IP address [-]
Default value 192.168.1.254 Alternative config NO
Step [-]
Comm object 24376 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint IP Address Mode (page
332)
Description
The setpoint is used to select the method how the IP Address is adjusted.
If IP Address Mode (page 332) is FIXED this setpoint is used to adjust the IP address of the ethernet interface
of the controller. Ask your IT specialist for help with this setting.
If IP Address Mode (page 332) is AUTOMATIC this setpoint is inactive. The IP address is assigned by the
DHCP server.
IP Address
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
