41IOM000 – Module with 1 monitored output with isolator
17/06/2020 14:06
41IOM000
Address
Loop Number
Device Zone
3
2
1
EnabledNewDevice State
More
Remove
OFF
Name
Save
17/06/2020 14:06
0
ON
Sounder Group
Led Blink
Software Revision
ID
2.0
3195011485
The figure shows the settings screen for module 41IOM000.
This module can be used to control an output used for controlling and monitoring audiovisual devices, electromagnetic
catches, etc.
For further technical information and module and output line wiring, please refer to the technical manual for this device.
Press “MORE” to access additional settings:
• LED Blink: select ON/OFF to enable/disable LED indications for the device.
If ON, the LED flashes at every panel dialogue cycle; if OFF, the LED does not flash during the dialogue cycle.
A name of up to 40 characters can be assigned to the output channel in the editable bar next to the “Name” label”.
Indications relating to the output status on the “More” page, and the configurable “rapid programming” options on the
monitored output of module 41IOM000, are the same as those listed in the paragraph concerning addressed module
41IOM022 (input channels).
To save any new parameters, press “Save” on the main device screen.
43
To Next Page
Loading...