To Next PageTo Next Page
Need help?Do you have a question about the ComNav 11101 and is the answer not in the manual?
General| Brand | ComNav |
|---|---|
| Model | 11101 |
| Category | Marine Equipment |
| Language | English |
Defines key terms and jargon used throughout the manual for clarity.
Explains the fundamental components and their interconnections.
Details how the autopilot performs steering commands and course changes.
Describes how the autopilot compensates for environmental factors.
Explains how to navigate along a programmed route or track.
Describes the manual steering mode using autopilot controls.
Details the primary user interface for controlling the autopilot.
Explains the core processing component of the autopilot system.
Discusses the types of compasses compatible with the system.
Describes the device that reports rudder position to the autopilot.
Covers the central hub for wiring autopilot components.
Outlines prerequisites for installing the autopilot system.
Instructions for mounting the Control Head and Signal Processing Unit.
Details on connecting power, rudder, navigation, and other signals.
Instructions for installing and positioning the compass sensor.
Initial system configuration before sea trials, including resets and tests.
Setting up the autopilot to recognize the connected compass type.
Verifying and adjusting the rudder's full range movement time.
Procedures for testing and tuning the autopilot underway.
How to use the primary automatic steering mode.
How to temporarily steer away from obstacles.
Explains different pre-programmed turning maneuvers.
Adjusting settings like rudder, turn rate, and yaw for optimal performance.
How to configure different steering parameters for varying speeds.
How the autopilot connects to external GPS or chartplotters.
Using the autopilot to follow a programmed route.
Navigating using a specific compass bearing.
A step-by-step guide for initial installation and setup.
Checklist for operational testing and parameter adjustment.
Checklist for testing navigation interface and modes.
Troubleshooting issues during initial system configuration.
Solutions for problems with rudder movement during testing.
Troubleshooting problems related to compass input or compensation.
Explains common error messages and their causes.
Addresses issues with data received from navigation equipment.
Details the terms and conditions of the product warranty.
Technical capabilities and operational limits of the autopilot.
Information regarding electromagnetic compatibility standards.
A logbook for recording custom parameter settings.
