9-12 Troubleshooting
Writer: Debbie Thomson Saved by: Debbie L. Thomson Saved date: 08/05/97 3:06 PM
Pages: 24 Words: 4414 Template: c:\msoffice\templates\comm.dot
File Name Ch9.doc Part Number 270844-002
Solving Memory Problems
continued
Problem Cause Solution
Insufficient memory error
during operation
Too many Terminate and Stay
Resident programs (TSRs) are
installed.
Delete any TSRs that you do not
need.
You have run out of memory
for your application.
Check the memory requirements for
the application, or add more memory
to the computer.
Solving SCSI
Problems
If you encounter SCSI device problems, refer to the common
causes and solutions listed in the following table.
Problem Cause Solution
System with IDE and
SCSI drives will not boot
from SCSI hard drive
The IDE drive is not disabled
through the Configuration
utility.
Run the Configuration utility and disable
the primary IDE drive.
System without an IDE
drive will not boot from a
SCSI drive
The SCSI drive is not
configured correctly.
Refer to the section “Installing a SCSI
Device” in Chapter 6 or Chapter 7, to
ensure that drive cabling and jumpers
are set correctly. To boot a SCSI drive,
the drive ID number must be set to 0.
To Next Page
Loading...
