5-2 Using the LS-120 and CD-ROM Drives
Writer: Debbie Thomson Saved by: Debbie L. Thomson Saved date: 06/09/97 4:09 PM
Pages: 7 Words: 1365 Template: c:\msoffice\templates\comm.dot
File Name Ch5.doc Part Number 270844-002
1. Insert a metal rod (approximately 1/16 inch in diameter and
at least 1 3/8 inches in length [1.2 mm × 35 mm]) into the
emergency eject hole, found in the center of the eject
button 1, and push firmly.
✎
You may use a straightened paper clip to eject the diskette
manually.
Manually Removing a Diskette from the LS-120 Drive
2. Slowly pull out the diskette from the drive to remove it.
✎
After manually removing a diskette, and before shipping
your computer, be sure to turn on power to the computer
to allow the diskette drive to reset the eject mechanism.
Creating Windows Disks
If you create a Windows 95 startup disk, use a 1.44-megabyte
diskette. A 120-megabyte diskette will not boot correctly.
To Next Page
Loading...
