7-12 Chapter 7, Removal and Replacement Procedures
7.7 POWER SUPPLY
The power supply is attached to the system board
by a power supply cable and connector.
To remove the power supply, follow these steps:
1. Complete the removal procedures in the
following sections:
a. 7.2 MONITOR
b. 7.3 KEYBOARD
c. 7.5 PREPARING THE SYSTEM UNIT
FOR THE INTERNAL REMOVAL
AND REPLACEMENT PROCEDURES
d. 7.6 SYSTEM UNIT COVER AND
INTERNAL CONFIGURATION
2. Locate the power supply assembly
(Figure 7-11).
Figure 7-11. Location of the Power Supply Assembly.
To Next Page
Loading...
